Axonics 2501 Manual Del Programador página 71

Programming the Neurostimulator
110-0085 rev E.indd 67
1
6
3
2
5
4
Manually Changing Electrode Configuration
The electrode configuration can be manually set by pressing the
electrode representations ( 3 ) to toggle each electrode between
its possible states. There are 3 possible electrode states:
Cathode (or "‐")
Anode (or "+")
Unassigned
If the electrode configuration is in "Monopolar" mode, the
Neurostimulator is set as the anode ("+") and the electrodes can
be toggled between cathode ("‐") and unassigned.
Note: When manually adjusting electrode assignment, invalid configurations
may be created. An alert will pop up if an attempt is made to exit this
screen, stimulate, or set the therapy settings ( 4 ) with an invalid electrode
configuration selected.
Typical invalid electrode configurations include:
More than 2 cathodes
•
2 cathodes that are not adjacent electrodes
•
More than 1 anode
•
Adjusting parameters
Several adjustable stimulation parameters are shown in the
"Stimulation Parameters" box ( 5 ).
To adjust frequency, amplitude range, and pulse width:
Press the left and right arrows to the sides of the current value
•
to incrementally decrease and increase the parameter.
67
5/7/2020 11:53:51 AM