Front Control Panel; Led Indicators - GALAGAR INVERMIG SYNER 230 MP Bi-PULSE Manual Técnico De Instrucciones

3.2. FRONT CONTROL PANEL.

ON
Green LED indicator of starp-up.
LD1
Amber LED indicator of equipment shutdown due thermal overload or input voltage conditions outside margin.
LD2
Welding process selection. Momentary pressure.
P1
Enter/Exit to/from SETTING MODE of cycle parameters. Maintained pressure (2 sec.)
Enter/Exit to/from SETTING MODE – L/CBP – Pulsed MIG momentary pressure when WELDING
P2 Welding program selection (Wire – Gas). (From MIG WELDING MODE).
Welding wire diameter selection. Momentary pressure from MIG WELDING MODE.
P3
Enter to TIMER MODE (process statistic). Maintained pressure.
Enter to JOB REPRODUCTION MODE from WELDING MODE. (Momentary pressure).
Exit from JOB MODE to WELDING MODE. (Momentary pressure).
P4
Enter to JOB RECORDING MODE from WELDING MODE. (Maintained pressure, 2 sec.).
JOB program recording from JOB RECORDING MODE. (Momentary pressure).
Gas purge. The gas solenoid valve is activated whilst depressed. The solenoid valve activation is prolonged
P5
for two seconds after pressing.
P6 Wire purge. The drive motor is activated whilst depressed.
+
+
+
ON
+
ON
GALA INVERMIG SYNER 230 MP Bi-PULSE
P3
D2
BUTTONS OF DIGITAL CONTROL PANEL
BUTTONS COMBINATIONS
Reset the setting parameters to factory values.
Reset to zero the counters from TIMER MODE. (By keeping pressed at the same time
+
buttons: P1, P3 and P4)
Deleting of JOB programmes. (Pressing P4 of maintained form in start-up process).
Momentary indication (display D1) of the number of working hours.
MANUAL Fe Ss CuSi
AlSi
AlMg
FCAW
Ar CO 18% 2%
CEL
2
m/ min
IPM
PULSE
JOB
0.6 mm .023"
0.8 mm .030"
1.0 mm .035"
TIMER
1.2 mm.045"
mm in
HOLD h
V A
% S
Hz %
ON

LED INDICATORS

P2
D1
P4
D3
44