Enter/Exit System To Job Mode; Timer Mode. Process Statistics; Enter/Exit Operation; Reset To Zero Of Timer Mode Counters - GALAGAR INVERMIG SYNER 230 MP Bi-PULSE Manual Técnico De Instrucciones

3.7.4. ENTER/EXIT SYSTEM TO JOB MODE.

P1: SELECT PROCESS
(for Job reproduction)
Note: if the message

3.8. TIMER MODE. PROCESS STATISTICS.

3.8.1. ENTER/EXIT OPERATION.

Select the process:
MIG/MMA/TIG.
AlMg
Ar
1.0 mm
V

3.8.2. RESET TO ZERO OF TIMER MODE COUNTERS.

SELECT PROCESS P1: MIG/MMA/TIG.
(It can be carried out from JOB mode)
GALA INVERMIG SYNER 230 MP Bi-PULSE
P4: ENTER TO JOB
MODE
JOB
appears on display D1, this is indicative that there are not programs recorded.
The indication appears after
keeping pressed for 1 sec. The
indication is maintained whilst
When it reaches 999 minutes it
changes into hours, and the
minutes indication will disappear.
mm
A
(thousands of hours /
E2: SELECT JOB No. TO
BE REPRODUCED
JOB
TIMER MODE
depressed.
1 s
min
TIMER
h
hours)
TIMER MODE P3
1 s
min
TIMER
h
JOB
D1: SELECTED
JOB
5 s
without
adjustment
activity
JOB
Wait for 2 seconds without
pressing.
2 s
without pressing
AlMg
Ar
1.0 mm
mm
V
RESET TO ZERO THE COUNTER
(Press for 1 sec. P1, P3 and P4)
1 s
1 s
min
TIMER
67
JOB
A
1 s