Cycle Parameters. Continuous Mig Process - GALAGAR INVERMIG SYNER 230 MP Bi-PULSE Manual Técnico De Instrucciones

3.4.4.3 CYCLE PARAMETERS. MIG PROCESS (CONTINUOUS).
K
EV
I2>0
Vh
TPR tacer
FDC
Torch
1T↓
CYCLE PARAMETERS FOR STANDARD MIG WELDING MODE IN CONTINUOUS CYCLE
Parameter
Electronic inductance level. (dynamic)
L
MOD Pulse mode (2T, 4T and 4T special)
TPR Gas pre-flow time.
IS Initial current (just in 4TS mode)
Current ramp-down time in arc-start and arc-end.
DWS
(just in 4TS mode)
IE End crater current (just in 4TS mode)
TPS Gas post-flow time.
FDC Approach speed.
TBB After-burning time correction.
DIM Dimensional system (Ø/vh).
REF Cooling mode
Tacer The time in approach process (Limited).
tci Time of interrupted cycle (Limited)
Troff2 Cooling disconnection time (AUT Mode)
Explanatory notes:
Tacer: The time that it is in approach process (I
tci : If the arc is manually interrupted (l
Troff2: The cooling will be disconnected in automatic work mode if a new cycle has not begun 120 seconds after a welding
process has finished.
GALA INVERMIG SYNER 230 MP Bi-PULSE
MIG PROCESS OPERATING CYCLES
MOD 2T (2 TIEMPOS)
TBB TPS
2T↑
K
EV
I2>0
IS-VhS
Vh
TPR tacer
FDC
Torch
1T↓
PARAMETER DESCRIPTION
=0) during the welding process, the cycle will be suspended if the welding
2
position (l
K
EV
Vh
TPR
FDC
Torch
1T↓
MOD 4TS (4 TIEMPOS ESPECIAL)
DWS
DWS
IE-VhE
2T↑ 3T↓
=0) will be limited to 5 sec.
2
>0) is not recuperated in 4 seconds.
2
MOD 4T (4 TIEMPOS)
I2>0
tacer
2T↑ 3T↓
TBB TPS
4T↑
CONFIGURABLE
VALUE
-10 ÷ 10
(20 positions)
2T; 4T; 4TS
0÷3.0 sec.
50÷400% vh
0÷10.0 sec.
10÷200% vh
0,0÷5,0 sec.
10 ÷100% Vh
-20 ÷ 20 (ms)
MM; IN
AUT/ON/OFF
Not adjustable value
Not adjustable value
Not adjustable value
53
TBB TPS
4T↑
FACTORY VALUE
0
2T
0.3 (sec.)
200 % vh
0.6 (sec.)
50% vh
0.5 (sec.)
33 (% vh)
0.00 (150 – 4*Vh)
MM
OFF
5 s max.
4 s max.
120 sec.