Mig/Mag Welding. Installation, Start-Up And Operation Systems; Mig/Mag Installations - GALAGAR INVERMIG SYNER 230 MP Bi-PULSE Manual Técnico De Instrucciones

3.4. MIG/MAG WELDING. INSTALLATION, START-UP AND OPERATION SYSTEMS.

3.4.1. MIG/MAG INSTALLATIONS.

Depending on whether the installation is cooled or not, we must set the equipment during the first start-up.
AUTOMATIC COOLING: Working mode with cooled torch.
The cooling only works in welding mode and will switch off automatically 2 minutes after carrying out the welding
process.
COOLING "ON" : Working mode with cooled torch.
The cooling works permanently after the first welding process starts.
COOLING "OFF" : It enables to work with torches without water cooling.
The cooling is deactivated, the protection against lack of water pressure is disabled.
Setting parameters adjustment system for (automatic) colled installation :
P1: SELECT THE
PROCESS
PULSE
PULSE
PULSE
GALA INVERMIG SYNER 230 MP Bi-PULSE
MIG
1º
P1: ENTER/EXIT TO
PARAMETERS
SETTING MODE
SETTING
PARAMETERS
PULSE
MIG PULSED
SPOT MIG
2º 3º
E1: SELECT CYCLE
PARAMETER
D2:
PULSE
PULSE
Bi- PULSED MIG
PULSED SPOT
MIG WELDING
4º 5º
E2: ADJUST VALUE
D3:
46
P1: SAVE
PARAMETERS
SAVED
PARAMETERS