Publicidad
Idiomas disponibles
Idiomas disponibles
Notice:
In the next step, the functionality of the
floor sensors is tested.
The display shows whether the test proce-
dure was successful or not.
Notice:
If the test procedure was not successful,
the procedure must be restarted.
If the test procedure was successful, you
can proceed to the next step.
• Open the front door.
• Bring the machine to the working position again.
• To do this, pull on the tank release lever for more ground
clearance and lower the tank carefully until it locks into the
holder.
• Close the front door.
• Finish the test procedure by pressing the arrow button.
Safety facilities
Notice:
This machine is equipped with various
safety facilities. These safety facilities en-
sure the safe operation of the machine by
detecting obstacles in the cleaning envi-
ronment.
Additionally, this machine is equipped with
floor detection sensors. The floor detection
sensors detect ground hollows (e.g. steps)
from 10 cm away.
As the last resort for obstacle detection,
this machine uses redundant touch detec-
tion.
Notice:
If a ground hollow is detected or an obsta-
cle is touched, the machine will be stopped
immediately by the ground detection sen-
sors and/or touch detection. Damage to
persons, machine and environment will be
prevented.
Attention:
Safety facilities such as redundant touch
detection and floor sensors must be
checked regularly for their functionality.
Malfunctions must be eliminated immedi-
ately.
Defective safety facilities can lead to per-
sonal injury, damage to the environment
and machine.
Caution:
Do not make any adjustments to the sen-
sors. This could have a negative effect on
safe operation!
LASER
1
• A class 1 laser (optional) can also be installed in this ma-
chine. On the laser the class is marked with the sign shown
below.
The functions of the machine can be extended by the laser.
Relocation drive
Manual mode:
The direction of travel is controlled by the driving handles and
the speed with the driving switches. The speed is continuously
regulated.
When the driving switch is released, the machine decelerates
until it stops and the parking brake is activated.
Notice:
The suction nozzle / squeegee is automat-
ically lifted and the cleaning solution sup-
ply is interrupted for reversing during
operating mode.
Transport mode:
For moving and loading the machine over a ramp or into a
transport vehicle, it must be put into transport position. To do
this, pull on the tank release lever for transport for more
ground clearance (see body overview page 69).
Notice:
All machine functions are deactivated in
transport mode.
Automatic mode:
When the cleaning program is started, the machine is set into
motion. The direction of travel and speed are automatically
controlled.
Moving the machine (in the case of a malfunction)
Notice:
Generally, the machine should only be
moved by two people.
Attention:
Due to the high weight, manual movement
of the machine is risky!
Missteps can lead to personal injury and
damage to the machine.
• Moving the machine is only possible when the emergency
stop button is permanently engaged.
EN
73
Publicidad
Capítulos
