allen A-71101-EU Manual Del Usuario página 38

Instructions for use
n. At each end of the
support top, insert
a cross pin into the
H-bracket, through
the support top
connector
assembly, and
through the other
end of the H-
bracket.
WARNING:
Do not use the support top without the cross pins installed correctly
through the H-brackets. To do so could cause patient fall, injury, or
equipment damage.
o. Make sure that—
–
All cross pins are correctly installed into the H-brackets and
support tops.
–
The drop lock on the end of the cross pins has moved to the
side to hold the support tops and H-brackets in position.
42. Loosely install a minimum of four safety straps evenly spaced and
around both support tops.
NOTE:
We recommend that you use the four Allen® Safety Straps that were
included with the support top.
43. Make sure the support tops are in the correct position, and then tighten
the safety straps.
44. Make sure the superior support top is progressively compressed against
the patient and once again tighten the safety straps.
45. Look at the display, and make sure the tilt
level indicator and the brakes locked
indicator are green.
38 Allen® Advance Table User Guide (D-720722 Ver D)