Fuses; Accessories - allen A-71101-EU Manual Del Usuario

76. Align the tab on the connector end of the new pendant cable with the
tab on the inside of the Allen® Advance Table connector.
77. Connect the pendant cable to the Allen® Advance Table connector.
78. Screw the nut on to the Allen® Advance Table connector.
79. Plug the Allen® Advance Table in, and turn it on.
80. Make sure all pendant functions operate correctly.

Fuses

Removal
81. Make sure the brakes are locked (the locked indicator on
the Allen® Advance Table display is green).
WARNING:
Failure to remove power from the Allen® Advance
Table could cause patient fall, injury, or equipment damage.
82. Turn the Allen® Advance Table off,
and unplug the power cord from the
facility's power source and from the
Table.
83. Pull the fuse holder from the plug
housing.
NOTE:
You may need to use a small
screwdriver or a pen to pry the holder
from the housing.
84. Remove the fuses from the holder.
Replacement
85. Install the new fuses in the holder.
86. Fully insert the holder into the plug housing.
87. Plug the power cord into the Allen® Advance Table and into an
applicable power outlet, and turn the Allen® Advance Table on.
88. Make sure all Allen® Advance Table functions operate correctly.

Accessories

For installation and use instructions, refer to the manufacturer's
documentation included with the accessory.
Allen® Advance Table User Guide (D-720722 Ver D)
Accessories
51