Installing Flame Broiler Slider Handle; Installing The Cooking Components; 26. Installing The Smoker Cooking Components - Pit Boss PLATINUM LOCKHART PB2180LK Instrucciones Y Recetas

24. INSTALLING THE FLAME BROILER SLIDER HANDLE
Parts Required:
1 x Main Grill/Hopper Assembly (#3)
1 x Flame Broiler Main Plate (#26)
Flame Broiler Slider (#27)
1 x
Flame Broiler Slider Pull Handle Connector (#22)
1 x
1 x Flame Broiler Slider Pull Handle (#23)
1 x Screw (#C)
Installation:
• Unlock the raised tab, Slide the notched end of the Flame Broiler Slider
Pull Handle Connector into the raised tab on the flame broiler slider, and
tighten the Flame Broiler Slider Pull Handle Connector with Flame Broiler
Slide Pull Handle with one screw, giving you adjustable access to the slider
on the main plate.
NOTE: When the flame broiler slider is open, and direct flame is used
while cooking, do not leave the grill unattended for any period of time.
Use: 1 pcs screws.
25. INSTALLING THE GRILL COOKING COMPONENTS
Parts Required:
1 x Main Grill/Hopper Assembly (#3)
2 x Porcelain-Coated Cast-Iron Cooking Grid (#28)
1 x Porcelain-Coated Steel Upper Warming Rack (#29)
Installation:
• Place the Cooking Grids, side by side, on the grid ledge inside the main grill
• Place the Upper Warming Rack on the upper ledge inside the main
grill. The Warming Rack will lock into place.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance Is required.

26. INSTALLING THE SMOKER COOKING COMPONENTS

Parts Required:
1 x Main Grill/Hopper Assembly (#3)
4 x Smoker Cooking Grid (#5)
1 x Grease Tray (#6)
Installation:
• Close the lid of main chamber
• Open door of smoker.
• From down to top , put 1 pcs Grease Tray and 4 pcs Smoker Cooking Grid.
14
24
25
26