Malossi MULTIVAR 2000 Manual Del Usuario página 33

5111258
Use the new Malossi roller guide cover
5 (Fig. 8). Fit them in their
the Malossi cursors
housings and follow the General assembly
instructions (page 29)
For this variator, absolutely do not use
lubricating grease. For all vehicles fitted with this
variator it is absolutely necessary to fit the spring
supplied in the kit.
ATTENTION: when fitting this variator on the
original driving shaft, the roller guide cover
6 is housed in a lowered area of the shaft
(Fig. 8), without creating any problem for
correct operation of the variator assembly. The
original shims 12 fitted in front of and behind
the fixed half-pulley must be replaced in their
original position.
Suggestions for the setting
The variator is supplied with two different roller
sets in order to change the number of revolutions
of the gear curve of your vehicle perfectly
adjusting its speed and acceleration.
• Tourist use
n° 6 rolls gr. 12,5
• Sports use
n° 3 rolls gr. 12,5 + n° 3 rolls gr. 9 placing them
in alternate way (Fig. 9)
• Racing use
n° 6 rolls gr. 9 (suggested setting with
modified exhaust)
Fig. 8
6 and
12 1 8 2
Fig. 9
gr. 12,5
gr. 9
gr. 12,5
3 4 5 76
lowered area
gr. 9
gr. 12,5
gr. 9
33
5111260
Suggestions for the setting
The variator is supplied with two different roller
sets: one of 9.5 gr. and one of 13.5 gr. in order
to change the number of revolutions of the gear
curve of your vehicle perfectly adjusting its speed
and acceleration.
• 125 - 150 cc : n° 6 rolls gr. 9,5
• 200 cc : n° 6 rolls gr. 13,5