Malossi MULTIVAR 2000 Manual Del Usuario página 37

» continue 5113134
DOODO 150 4t LC
SKYLINER 125 4t LC
SKYLINER 150 4t LC
THUNDER 125 4t LC
THUNDER 150 4t LC
YAMAHA
MAJESTY 125 4t LC
MAJESTY 150 4t LC
MAXSTER 125 4t LC
MAXSTER 150 4t LC
TEO'S 125 4t LC
TEO'S 150 4t LC
Fig. 22
gr. 10,5 gr. 8
gr. 8
gr. 10,5 gr. 8
5113322
In order to get to the variator, remove the plastics
around the area indicated by the arrow
following the instruction of the vehicle handbook
"Use and maintenance".
• Remove the crankcase cover which covers
the variator.
• Unscrew the variator lock nut on the crankshaft
and remove the original variator from
the vehicle.
Proceed as follows on the Malossi variator:
• Insert the hub into the movable half-pulley,
taking care not to damage the oil-seal rings;
• Insert the rollers in their seats;
• Use the original roller guide cover and
the original sliders. If they are excessively
worn or damaged, replace them with new
gr. 10,5
original sliders;
• Clean carefully and remove the grease from the
movable half-pulley using a suitable solvent;
• Fit the variator on the crankshaft tightening the
original nut, as it is shown in the handbook "Use
and maintenance";
• Close the cover and fit the complete unit
following backwards this instruction.
Fig. 23
(Fig. 23)
37