APRILIA MX 125 Manual De Instrucciones página 237

CHECKING AND TOPPING UP
WARNING
Check the coolant level and top up the
expansion tank with cold engine.
Stop the engine and wait until it has
◆
cooled down.
CAUTION
Position the vehicle on firm and flat
ground.
Keep the vehicle in vertical position, with
◆
the two wheels resting on the ground.
Rotate the radiator cap (1) anticlockwise,
◆
giving it one click.
Wait for a few seconds, in order to permit
◆
the bleeding of any pressure present in
the system.
Rotate the radiator cap (1) anticlockwise
◆
again and remove it.
1
Check if the coolant covers the radiator
◆
plates completely.
If necessary, top up with coolant, see
◆
pag. 88 (LUBRICANT CHART), until
covering the radiator plates completely.
WARNING
Do not exceed this level, otherwise the
fluid will flow out of the tank when the
engine is running.
WARNING
The coolant is noxious: do not swallow
it; if the coolant gets in contact with the
skin or the eyes, it can cause serious
irritations.
Do not use your fingers or any other
object to check if there is enough
coolant.
CAUTION
Do not put additives or other subtances
into the fluid.
If you use a funnel or other similar
items, make sure that they are perfectly
clean.
Put back the radiator cap (1).
◆
WARNING
In case of excessive consumption of
coolant and in case the tank remains
empty, make sure that there are no
leaks in the circuit.
Have it repaired by an aprilia Official
Dealer.
use and maintenance MX 125
45