Rear Wheel - APRILIA MX 125 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
7
6
9

REAR WHEEL

WARNING
The disassembly and reassembly of the
rear wheel may be difficult for unskilled
operators. If necessary, contact an
aprilia Official Dealer.
If you want to perform these operations
personally, keep to th e following
instructions.
Carefully read pag. 55 (MAINTENANCE).
Before carrying out the following
operations, let the engine and the
silencer cool down until they reach
room temperature, in order to avoid
burns.
While disassembling and reassembling
the wheel, be careful not to damage the
brake pipe, the disc and the pads.
use and maintenance MX 125
64
1
2
For the disassembly and reassembly,
use gloves in order to protect your
hands and fingers properly.
Riding with damaged rims may be
dangerous for the rider, other persons
and the vehicle.
Check the conditions of the wheel rim
and change it if it is damaged.
DISASSEMBLY
Position the vehicle on the stand.
Loosen and remove the two screws (1).
Remove the chain casing (2).
Loosen the wheel nut (3) .
Wheel nut (3) driving torque:
100 Nm (10 kgm).
8
3
WARNING
4
WARNING
Upon reassembly, before tightening the
wheel nut (3), check the chain tension,
see pag. 66 (DRIVE CHAIN).
Due to the weight and dimensions of
the vehicle, the following operation
cannot be performed by one person
only.
Proceed with care and make sure that
you can support the weight of the
vehicle.
CAUTION
W e i g h t o f t h e v e h i c l e ( r e a d y f o r
starting): 126 kg.
Raise the rear part of the vehicle, have a
suitable support (4) (the height of which
should be 400 mm) placed under the
engine, so that the rear wheel can rotate
freely and the vehicle cannot fall down.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido