Stryker M-1 Manual De Instrucciones página 28

P P e e d d i i - - M M a a t t e e ® is a registered trademark of Ferno Washington, Inc.
I I n n s s t t a a l l l l i i n n g g t t h h e e d d e e f f i i b b r r i i l l l l a a t t o o r r p p l l a a t t f f o o r r m m
C C A A U U T T I I O O N N
• Always secure the defibrillator platform to the product when you use the defibrillator platform.
• Always use and adjust the straps that are provided with the defibrillator platform to secure the defibrillator.
• Always change the installation location or adjust the straps for your specific defibrillator size or shape.
• Do not load the defibrillator platform above the safe working load of 30 lb (13.6 kg).
To install the defibrillator platform:
1. Place the defibrillator platform in the stored position (Figure 17).
2. Open and expand the defibrillator platform legs (Figure 18).
F F i i g g u u r r e e 1 1 7 7 – – S S t t o o r r e e d d p p o o s s i i t t i i o o n n
3. If the product is equipped with an IV pole, raise the IV pole (A) to the up position (Figure 19).
4. Place the defibrillator platform on the product frame.
5. Position the inside legs (B) of the defibrillator platform toward the head end of the product (Figure 19).
6. Place the latch hook (C) under the litter frame or foot end fastener and push the tab (D) up until it locks into place on one
side with an audible click. Repeat on the other side. For P P o o w w e e r r - - L L O O A A D D compatible cots, if equipped, you must lengthen
and attach the straps to the foot end fastener (Figure 21).
EN 24
F F i i g g u u r r e e 1 1 8 8 – – O O p p e e n n d d e e f f i i b b r r i i l l l l a a t t o o r r p p l l a a t t f f o o r r m m l l e e g g s s
6100-109-005 Rev D.1