Stryker M-1 Manual De Instrucciones página 20

R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e b b a a c c k k r r e e s s t t
To raise the backrest, squeeze the backrest adjustment handle to move the backrest to the desired height.
To lower the backrest, squeeze the backrest adjustment handle while you push down on the backrest to the desired height.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e s s i i d d e e r r a a i i l l s s
Always lower the siderails when you transfer a patient to the cot or from the cot.
W W A A R R N N I I N N G G - - Do not use siderails as a patient restraint device.
To raise the siderails, lift up on the siderail until the latch clicks and the siderail locks into place. Always keep the siderails in
the raised position unless you are transferring the patient.
To lower the siderails, squeeze the siderail release handle to release the siderail latch. Guide the siderail down toward the
foot end of the cot until the siderail lays flat. Always lower the siderails when you transfer a patient to or from the cot.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e f f o o o o t t r r e e s s t t
You can adjust the footrest to elevate the patient's legs.
To raise the footrest, lift the frame as high as possible. The support bracket automatically secures the frame when you
release the footrest.
To lower the footrest, lift the frame and lift up on the footrest release handle until the frame releases the support bracket.
Lower the footrest until it lays flat.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e o o p p t t i i o o n n a a l l k k n n e e e e G G a a t t c c h h
To raise the optional knee Gatch:
1. Lift either of the red lifting loops (A) until the knee Gatch is in the highest position (Figure 6).
2. Lower the knee Gatch to secure the support bracket to the locking mechanism.
3. Make sure that the locking mechanism is secure before you release the lifting loop.
To lower the knee Gatch, lift either of the red lifting loops (A) to relieve pressure on the locking mechanism, and while
holding the loop, push on the red footrest release handle (B) until the support bracket is released. Lower the knee Gatch
until it lays flat.
To raise the knee Gatch in trend, lift the footrest frame (C) as high as possible until the frame locks into place. The support
bracket automatically connects when you release the frame.
To lower the knee Gatch in trend, lift the footrest frame (C), and while holding the frame, lift up on the red footrest release
handle (B) until the frame releases the support bracket. Lower the footrest until it lays flat.
N N o o t t e e - - The optional foot end oxygen bottle holder (6500-240-000) is not compatible with the optional knee Gatch (6500-
082-000).
EN 16 6100-109-005 Rev D.1