Kärcher MC 130 Classic Manual Del Usuario página 100

Securing the raised waste container
WARNING
Risk of injury and damage
Always secure the waste container when working with a raised
waste container.
Retaining pins
1
Locking pin
2
Storage for safety bolts with safety bracket (2x)
3
Secured position (1x right, 1x left)
4
1. When the waste container is raised, use safety bolts and se-
cure with the safety brackets (2x).
Securing the tipping device
Piston rod
1
Locking pin
2
Safety bracket
3
Safety bracket mount
4
1. Raise the tipping device all the way.
2. Open the locking pin.
3. Remove the support from the bracket.
4. Insert the bracket.
5. Fit the locking pin.
Note
Locking pins can be applied to the left and right piston rods.
Lowering the tipping device
ATTENTION
Damage to the suction hose
When lowering the tilting frame, make sure that the suction hose
goes into its guide properly.
100
Suction hose
1
1. Lower the tilting frame after removing the safety support.
2. If necessary, manually insert the suction hose into the guide.
CAUTION
Risk of injury
Risk of burns from hot vehicle parts.
Allow the unit to cool down sufficiently before opening the side
panels.
(1)Locks
(2)Side panel
On both sides
1. Open side panel locks.
Right side
2. Open the side panel towards the front.
Left side
3. Pull the main switch to unlock the left side panel.
4. Open the side panel towards the front.
English
Open the side panel