Installation Information - Kärcher MC 130 Classic Manual Del Usuario

Removing/installing the radiator protective grille
1. Lift the radiator protective grille upwards.
2. Pull out the lower part.
3. Remove the radiator protective grille downwards.

Installation information

Engage the radiator protective grille at the bottom, then snap shut
at the top.
Checking the coolant level and topping up the coolant
CAUTION
Risk of burns on account of hot components
Do not open or touch the radiator or parts of the cooling system
while the motor is hot.
ATTENTION
Damage to property due to incorrect coolant
Only top up coolant when the motor is cool.
Use water-based anti-freeze.
Do not mix different anti-freeze types.
Only used softened water.
For coolant refer to chapter .
Cover
1
Expansion reservoir
2
Upper filling level marking
3
Lower filling level marking
4
1. Check the filling level when the engine is cold.
2. Remove the left side panel.
3. Check the filling level in the expansion reservoir.
Note
The coolant level must be between the upper and lower mark-
ings.
4. Top up the coolant if necessary.
5. Also check the filling level in the radiator, see chapter .
6. If the expansion reservoir is totally empty, top up the radiator
first.
Checking the hydraulic oil level and topping up the hydraulic
Hydraulic fluid
1
MIN oil level
2
MAX oil level
3
1. Check the hydraulic oil level.
Note
The hydraulic fluid must be between the upper and lower
markings.
2. Top up the hydraulic oil if necessary.
Note
Lacking hydraulic oil can be topped up using a special acces-
sory tool connected to the leakage coupling on the vehicle. If
required, request the order no. at Kärcher or have Kärcher
Customer Service do the topping up.
For the hydraulic oil grade, see chapter Technical data.
Topping up the coolant in the radiator
CAUTION
Risk of burns on account of hot components
Do not open or touch the radiator or parts of the cooling system
while the motor is hot.
ATTENTION
Damage to property due to incorrect coolant
Only top up coolant when the motor is cool.
Use water-based anti-freeze.
Do not mix different anti-freeze types.
Only used softened water.
For coolant refer to chapter Technical data.
1. Remove the waste container, see chapter
English
oil
101