Switch Panel; Waste Container Controls; Ignition Lock; Spray Controls - Kärcher MC 130 Classic Manual Del Usuario

Air recirculation lever
1
Ventilation nozzles
2
Pull the air recirculation lever forwards.
ATTENTION
Only use this function for a limited period, since air is not ex-
changed from the outside with this setting.

Waste container controls

The switch for emptying the waste container is located next to the
driver's seat.
Additional socket-outlet, 12 V
1
Raise the waste container/attachment frame
2
Lower the waste container/attachment frame
3

Spray controls

Left side brush spray dosage knob
1
Right side brush spray dosage knob
2
Suction mouth spray dosage knob
3
1. Switch on the water pump (control panel).
2. Turn the corresponding dosage knob.
Note
Turning to the left increases the spray water volume. Turning to
the right increases the spray water volume.
Warning flasher system switch
1
Lighting switch
2
Position 0: Driving light off (pressed down)
Position 1: Parking light on (middle position)
Position 2: Driving light on (pressed up)
Working light switch
3
Rear fog lamp switch (option)
4
Front working light switch
5
Flashing beacon switch
6
Switch for heatable outside mirror (option)
7
The heating switches off again automatically
Heated windscreen switch
8
The heating switches off again automatically
Seat heater switch
9
Note
The indicator in the switch lights up when it is switched on.
Engine off
1
Ignition on
2
Preheating (automatic)
3
Start the engine
4
The ignition lock is located below the travel direction lever.
English

Switch panel

Ignition lock

69