Kärcher MC 130 Classic Manual Del Usuario página 87

Suction hose
1
Waste container
2
16.Install the suction hose between the waste container and suc-
tion mouth.
Removing the waste container
DANGER
Risk of crushing when lowering/raising the waste container
Maintain sufficient clearance to the waste container and the roll-
ers on the parking supports.
Maintain sufficient clearance to hazard zone and stop raising/
lowering immediately when a person enters the hazard zone.
ATTENTION
Risk of injury and damage
Empty the waste container and water reservoir before removing
Set the waste container down only on a level and smooth surface.
Suction hose
1
Waste container
2
1. Turn the steering wheel all the way to the right to provide better
access to the articulated joint.
2. Disconnect and remove the suction hose from the waste con-
tainer.
Water connections
1
3. Disconnect the hoses for water recycling, fresh water and the
high-pressure cleaner (optional).
4. Steer the vehicle straight ahead.
Retaining pin for waste container with locking pin
1
Rear parking supports
2
Height adjustment with bolts and retaining clips
3
Safety lever with retaining clips
4
5. Open the locking pin for the waste container from the retaining
pin and remove it.
6. Pull out the retaining pin.
7. Adjust the rear parking supports to an appropriate height and
secure in this position.
a The corresponding height depends on the tyre type and the
tyre pressure.
8. Push in the rear parking supports all the way to the end stops
and secure in this position. To do this, press the safety lever
down and push in the supports as far as they will go. Then se-
cure the safety lever with the retaining clip.
9. Depressurise the hydraulic system, see chapter .
10.Disconnect the electrical and hydraulic connections from the
waste container.
English 87