Kia Sorento 2011 Manual Del Usuario página 976

Second Generation XM (2011-2015) / Kia Sorento XM 2011-2015 Service Manual / Brake System
Kia Sorento: Brake System - ESC(Electronic Stability Control) System - Rear Wheel Speed Sensor Removal
4WD only
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
1.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)
2.
3. Remove the rear wheel guard.
Disconnect the rear wheel speed sensor connector (A).
4.
Installation is the reverse of removal.
Install the rear sensor after lubricating the O-ring of sensor with the assembly fluid(RAREMAX AF-1). When inserting the sensor,
take care the O-ring not to be damaged.
5.
2WD only
Remove the connector (A) after removing the front wheel speed sensor clip.
1.
Remove the rear wheel speed sensor. (Refer to Driveshaft and Axle -
2. "Rear Hub - Carrier")
3. Installation is the reverse of removal.
www.bestservicemanual.com