Recording; Serato Itch Effects Panel Overview - Numark NS7 Manual De Referencia

RECORDING

Serato ITCH can capture recordings of your Program Mix or NS7's MIC / AUX INPUT channel. Recording controls are grouped into a
menu above Deck B in the software. To record:
3
1. In the software, click the Record Source Selector and select your source from the drop-down menu. Selecting "Mix" will record
the master output signal – post-faders/-EQ, and pre-MASTER VOLUME. Selecting "Aux" will record the NS7's MIC / AUX signal
only.
2. Adjust the recording level using the appropriate controls for the source being recorded. The Recording Meter in the software
shows the signal level that will be recorded to disk. We recommend that you set your levels so the loudest part of the mix causes
the meter to enter the red zone only briefly.
3. To show or hide the channel controls for the MIC / AUX INPUT, click the Mic / Aux button.
4. Click the Record button to start recording. The length of the recording will be displayed in the Recording Timer. Press it again to
stop recording.
5. Type a filename into the Recording Filename text field, and click Save. Recordings are saved as 16-bit 44.1 kHz stereo files
(.AIFF) in the "Recorded" Crate inside your Main Library folder. The files can be accessed in My Documents
Scratch LIVE Recording (Windows) or Users

SERATO ITCH EFFECTS PANEL OVERVIEW

1
1. NEXT EFFECT – The next effect in the sequence of available effects. Press the NSFX's / V7's FX SELECT knob to select this
effect.
2. CURRENT EFFECT – The currently selected effect applied to the channel (if the NSFX's / V7's FX ON / OFF button is set to "on").
When the effect is on, the CURRENT EFFECT and NEXT EFFECT windows will light up.
3. FX MIX – The amount of CURRENT EFFECT, which can be adjusted with the NSFX's / V7's FX MIX fader.
4. PARAMETER – The parameter for the CURRENT EFFECT, which can be adjusted with the NSFX's / V7's FX PARAM knob.
Generally, this is the intensity of the effect but may vary between effects.
5. SOURCE – The channel to which the CURRENT EFFECT is being applied. You can select the channel with the NSFX's / V7's
SOURCE knob.
Note: When both SOURCE fields are set to the same channel, that channel will pass through the left effect then the right effect.
6. TEMPO SOURCE – The current BPM for the track, which helps determine the speed of the CURRENT EFFECT (if it is rate-
based). When this field reads "AUTO A" or "AUTO B," the effect will automatically follow the BPM of the track on Deck A or Deck
B, respectively. If "MANUAL" is shown, it means neither Deck's track has a BPM. You can set the BPM (and change it at any
time) by using the NSFX's TAP TEMPO button. You can also return to the track's auto-BPM by holding down TAP TEMPO.
All manuals and user guides at all-guides.com
4 1 2
Music Scratch LIVE
2 3
29
4 5
Recording (Mac).
4 5
5
My Music
6