Stopping The Machine; Troubleshooting And Possible Remedies - Rancilio EPOCA Serie Instrucciones Originales

● Put the softener back on the rubber tube and
replace it horizontally on the bottom of the tank.
● On completion of this operation, the machine can
be started up again by repeating the procedure
described in paragraph 7.3.
Whenever descaling operations are ne-
cessary, ensure that only specific products
suitable for parts contacting water for public,
human consumption are used. Make sure
that all the relative product instructions are
carefully observed and complied with at all
times.

12. STOPPING THE MACHINE

A - Temporary stop
● Carry out cleaning and maintenance operations.
● Wind up the cable and fasten it to the machine
with sticky tape.
● Cover the machine and place it in a dry room. Do
not leave it exposed to atmospheric agents and
do not allow it to be touched by children or unift
persons.
To disconnect from the main power supply, consult
qualified personnel.
B - Definitive stop
● Besides carrying out the operations necessary for
a temporary stop, cut off the cable, pack the ma-
chine in cardboard, polystyrene or other packing
material and consign it to firms authorized for its
disposal or to second-hand goods dealers.
66
13. TROUBLESHOOTING AND POSSIBLE
REMEDIES
Check operations to be carried out by the
user with the plug disconnected.
For any type of problem or inconvenience
not specifically indicated, disconnect the
plug and contact our service centre without
attempting any direct repairs.
A) The machine does not start:
- check that the plug is connected;
- In case of power failure wait for the power to return
and check if the earth leakage protection circuit
breaker or the main switch is on;
- check the condition of the plug and the supply
cable; if damaged have them replaced by qualified
personnel.
B) There is water under the machine:
- check that the drainage tray is not obstructed.
C) Slow dispensing:
- check that the filters and delivery heads are
clean;
- check that the coffee is not too finely ground.
D) Irregular steam delivery:
- check that the nozzles are not obstructed.