Husqvarna TC 2011 I.E. Serie Manual Del Usuario página 102

HEADLAMP BULB REPLACEMENT (TE)
5
Proceed as follows to reach the headlamp bulbs:
2
- Loosen upper screw (1) using an 8 mm wrench;
- loosen the two lower screws (2) using a Phillips screwdriver;
- move headlight unit (3) aside;
- release connector (4);
- slide off the rubber gaiter (5);
- release the bulb holder clips (6) and take out bulb (7);
Note*:
Headlamp bulb (7) is of the halogen type; be care-
ful when replacing it since the glass part shall not be
touched with bare hands.
3
6
7
4
1
EN - 48