Husqvarna TC 2011 I.E. Serie Manual Del Usuario página 97

REMOVING THE FRONT WHEEL
Set a stand or a block under the engine and see that the
front wheel is lifted from the ground.
- Loosen screws (1) securing wheel axle (2) onto fork
leg mounts.
- Hold wheel axle head and, at the same time, loosen
screw (3) on the opposite side; draw the wheel axle out.
Note *:
Do not operate the front brake lever when the wheel has
been removed; this causes the calliper pistons to move
outwards. After removal, lay down the wheel with brake
disc on top.
1 1
2
1
3
EN - 43