Husqvarna TC 2011 I.E. Serie Manual Del Usuario página 75

ENGINE STARTING (TE-TXC)
With cold engine, i.e., after the motorcycle has not
been used for a while or in low ambient temperatures,
operate in the following manner:
1) For model (TE) only
turn key (1) in the ignition switch to ON (the hum
you may hear when key is turned to ON is caused by
the fuel pump pressurising the delivery system);
2) pull clutch lever (2);
3) shift gear pedal (3) to neutral position;
4) Press starter button (4).
When a cold engine has just been started, do not
increase revs, to ensure an adequate oil warm-up
and circulation.
Note *:
A safety switch is set on the clutch lever support. This
switch allows you to ONLY start the engine with the
gearbox idle, or with the gear engaged and the clutch
lever pulled.
IMPORTANT
NEVER START ENGINE WITH BATTERY DIS-
CONNECTED FROM CIRCUIT.
TE
1
TE
2
TXC
2
N
3
4
EN - 21