The width of the sweeping track should lie
between 40-50 mm.
Set the sweeping track using the two
adjusting screws.
Check sweeping mirror.
Adjust the side seals
Check tyre pressure.
Drive the waste container up and se-
cure it with the safety rod.
DANGER
Risk of injury! Always apply the safety bar
when the waste container is raised.
Perform the safeguarding only from outside
the hazard zone.
Fold the safety rod for the high empty-
ing up and insert it into the holder (se-
cured).
1 Holder of safety rod
2 Safety rod
Open the side cover as described in
Chapter "Replace brush roller".
Release the 6 wing nuts on the side
holding plate.
Loosen 3 nuts (SW 13) on the front
holding plate.
Press the side seal down (elongated
hole) until it is about 1 to 3 mm to the
floor.
Screw in the holding plates.
Repeat the procedure on the other side
of the appliance.
32
Check the tyre pressure
Park the sweeper on an even surface.
Connect air pressure testing device to
tyre valve.
Check air pressure and adjust if required.
For permissible tyre air pressures see
"Technical data".
Manually clean the dust filter
Clean the dust filter with the filter clean-
ing button.
Replacing dust filter
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
1 Lock of appliance hood
2 Cover
Open the lock, remove the star grip
screw to do this.
Fold cover forwards.
2
1
1 Lock
2 Filter cover
Open filter cap.
Fold the filter vibrator forward.
Replace the dust filter.
Close the filter cover.
12
-
EN
Check and adjust the V-Belt
The V-Belt must deflect approx. 7-9 mm at
a pressure of 10 kg.
Get the V-belt tension adjusted by an
authorized customer service.
Check air filter and replace, if necessary
1 Lock
2 Air filter housing
Open the lock.
Remove the air filter housing.
Replace the air filter insert.
Note: Installation position with blowout
opening pointing down (see illustra-
tion).
Unscrew the wing nut from the centrifu-
gal separator.
Clean the centrifugal separator.
Changing the headlight bulb (option)
Unscrew the head lamps.
Take out the head lamps and pull out
the plug.
Note: Note the positions of the plugs.
Dismantle the head lamps.
Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
Unlock the bracked and take out the
bulb.
Insert new bulb.
Reinstall in reverse sequence.
Changing the blinker bulb (option)
Note: Remove the glass of the direction-in-
dicator lamp from its casing to replace the
bulb.