Operation - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

EN
Check tyre pressure
Check the tyre pressure on all wheels and correct
Î
it where necessary (for max. tyre pressure, see
tyre wall).
Adjusting the driver's seat L M
(depending on the design and model)
Seat with adjustment lever L
Sit on the driver's seat.
Î
Press the adjustment lever to the left and keep it
Î
held 1 .
Bring the seat to the desired position 2 and leave
Î
the adjusting lever 3 .
Note
When releasing the adjustment lever, make
sure the seat latches in correctly.
Seat without adjustment lever
Fold the seat forward 1 .
Î
Remove the tommy screws [1] 2 and move the
Î
seat to the desired position 3 .
Refit the tommy screws and tighten 4 .
Î
Fold the seat back 5 .
Î
Adjusting the drive control levers K
Depending on requirements, the drive control levers
can be adjusted higher, lower and longitudinally.
Height adjustment Ka :
Remove the screws [1] and nuts [3] 1 .
Î
Push the drive control lever [2] upwards or
Î
downwards and fix the drive control lever with the
screws and nuts in the other pair of holes of the
mount 2 .
Note
There are three height setting options in
total.
Longitudinal adjustment Kb :
Release the clamping screw [1] 1 .
Î
Move the control lever [2] forwards or backwards
Î
into the desired position 2 .
Re-tighten the clamping screw [1] 3 .
Î
Note on adjusting the drive control lever:
Both levers should be installed at the same
position (height and length adjustment).
The levers should be configured as follows:
In the neutral position, with hands on the
control levers, the upper arms of the user
should be relaxed and approximately verti-
cal, while the lower arms should be approxi-
mately horizontal.
16
M
Note on drive control lever adjustment in
connection with seat adjustment
In the foremost position, the driver's back
should stay in contact the backrest, and the
drive control levers must not come into con-
tact with the legs of the user.
In the rearmost position, the drive control
levers should not come into contact with the
legs or the body of the user.
Set the seat to the desired operating position.
Setting the cutter wheels J
The cutter wheels should never be lower than
6-12 mm above the ground at the lowest cutter
position. The cutter wheels are not designed to bear
the loads generated by the cutters and may have
to be offset accordingly. They are used solely for
compensating for floor unevenness.
Always move the cutting wheels so they line up
Î
evenly.
Note
The number of cutter deck wheels varies
depending on the model.

Operation

Attention!
¾ Also observe the information in the operating
manual for the engine.
Note
Comply with the national/municipal regula-
tions concerning the times when the appli-
ance may be used (if required, contact your
local authority).
Switching the headlights on/off A
(optional - depending on the model)
Switching on
The headlights [P] come on as soon as the
Î
ignition key is turned from the STOP position
towards / .
Switching off
The headlight is switched off, if the ignition key is
Î
in the STOP position /
Applying/releasing the parking brake G H
To apply the parking brake
Î
control levers into the neutral position fully out into
the recess H [A].
To release the parking brake, pull both drive
Î
control levers inwards into the neutral posi-
tion [N] Ga .
Operation
.
, push both drive