Pre-Flight Checklist - DJI MATRICE 30 Serie Manual Del Usuario

Pre-Flight Checklist

The pre-flight checklist can be used as a reference for pre-flight check in daily operations.
1. Make sure the remote controller and the aircraft batteries are fully charged, the TB30 batteries are installed firmly, and the
battery release toggles are locked.
2. Make sure the propellers are securely mounted and not damaged or deformed, that there are no foreign objects in or
on the motors or propellers, that the propeller blades and arms are unfolded, and that the frame arm folding buttons are
popped out in the locked position.
3. Make sure the lenses of the vision systems, cameras, FPV, the glass of the infrared sensors, and the auxiliary lights are
clean and not blocked in any way.
4. Make sure the gimbal is unlocked and the camera is facing the front of the aircraft.
5. Make sure the covers of microSD card slot, the PSDK port, and the dongle compartment have been closed firmly.
6. Make sure the remote controller antennas are adjusted to the proper position.
7. Power on the aircraft and the remote controller, toggle the flight mode switch to N-mode. Make sure the status LED
and the aircraft authority button on the remote controller are solid green. This indicates that the aircraft and the remote
controller are linked and the remote controller is in control of the aircraft.
8. Place the aircraft on open and flat ground. Make sure there is no obstacles, buildings, or trees nearby, and that the
aircraft is 5 m away from the pilot. The pilot should be facing the rear of the aircraft.
9. To ensure flight safety, enter the flight view of DJI Pilot 2 and check the parameters on the pre-flight checklist such as the
control stick mode, RTH height, obstacle distance, and failsafe settings. It is recommended to set the failsafe action to
RTH.
10. Divide the airspace for flight when multiple aircraft are operating simultaneously in order to avoid collision mid-air.
Fly in Open Strong GNSS
Areas Signal
DO NOT use the aircraft in adverse weather conditions such as rain, snow, fog
and wind speeds exceeding 15 m/s or 33.5 mph.
* 12 m/s during taking off and landing.
2
120 m
Maintain Visual Fly Below 400
Line of Sight feet (120 m)
≥
15 m/s*
Avoid flying over or near crowds, trees or airports.
Strong electromagnetic sources such as power lines, base stations, and tall
buildings may affect the onboard compass. Always stay alert about surroundings
in flight.
If there are obstacles on the flight route, fly the aircraft higher to avoid the
transmission signal being blocked.
Stay away from the rotating propellers
and motors.
GEO Zone
Learn more at:
https://www.dji.com/flysafe