Permobil BodiLink Lateral Trunk Supports Operación Manual página 10

INSTALLATION - TRACK MOUNT ON CORPUS 3G
For GT2 hardware styles. All required tools are provided.
In some cases, the LTS hardware will already be attached to the track mount bracket (E). If height, width or depth
adjustments are needed, loosen but do not remove the bolts (A) using the 5mm hex key, and slide the link (D) into
position. Tighten the bolts (A) to secure. This can also be done after the track mount bracket is installed on the Corpus
shell.
1
Line up the bolts (A) with the safety
washers (B), the slot-lock double
washer (C), the slots on link (D), the
slot on track mount bracket (E) and the
slot-lock double nut (F).
Note: The bolts (G) on the LTS hardware
should face up, and the curved edge of
the track mount bracket (E) should be
oriented towards the support pad.
2 Tighten the bolts (A) using the 5mm
hex key. Follow these steps for each
set of hardware needed. Continue to
step 3.
3
Remove the back support cushion (H)
from the back shell (J), pulling forward to
separate the hook and loop attachment.
4
Locate the existing 3 bolts along the
rear-facing, outside edge of back shell (J),
next to the armrest. Remove the 3 bolts
to release the existing height adjustment
track and the plastic lateral wedges (not
shown) attached to the front face of the
back shell (J). Discard the removed parts or
retain for future use.
5
Line up the provided button head bolts (K)
with the back shell (J) and the track mount
bracket (E). Tighten the bolts (K), using the
3mm hex key.
Recommendation: For better access to the
bottom bolt, lift the armrest.
6 Adhere the replacement foam support
pads (L) to the back support cushion (H).
The support pads (L) adhere with a hook
and loop attachment and can be placed
wherever the lateral support is needed.
7
Replace the back support cushion (H)
on the back shell (J). Continue to the
"Adjustment and Use" section for final
hardware adjustments and support pad
positioning.
BodiLink Lateral Trunk Support Operation Manual
E
D
F
J
K
8
A
C B
G
Swing-Away GT2 Hardware
E
H
L