Permobil BodiLink Lateral Trunk Supports Operación Manual página 20

CLEANING
WARNINGS:
- Follow all manufacturer bleach container and germicidal disinfectant safety guidelines.
- Before transferring to a new user, the product must be completely cleaned and disinfected.
- Periodically, check the cover and components for damage and wear, and replace if necessary. Some wear with regular use
is expected.
CAUTION: Frequent heat drying and bleaching will cause fabric to break down. Air drying and cleaning without bleach
are recommended whenever possible to help extend the life of the cover.
Spray with common household or commercial antibacterial cleansers or disinfectants. Wipe with a
damp, water-only cloth after disinfecting. Let dry completely before use.
CAUTION: DO NOT wash or dry Stretch-Air, COMFORT-TEK or GlideWear covers with hook and loop fasteners or other
materials that could snag the fabric. Doing so could pull at the fabrics, causing changes in the appearance (but not the
effectiveness) of the fabrics.
IMPORTANT! Before cleaning or disinfecting, remove the cover (and foam, for the Premium Pad) from the support pad
and hardware.
Cleaning: When possible, hand wash in warm water with mild soap, rinse thoroughly
with clean water, and air dry (let dry completely before use). Or machine wash using
common laundry detergent and tumble dry low.
Disinfecting Premium Pad: Wash the cover with water and bleach. Rinse thoroughly. Follow the directions on the
bleach container. Let dry completely before use. May hand wash with bleach using 1 part household liquid bleach
per 9 parts warm 40°C/104°F water. Rinse thoroughly with clean water. Let dry completely before use.
Disinfecting Basic Pad: Machine wash hot using common laundry detergent. Tumble dry low.
Let dry completely before use.
WARNINGS: DO NOT use contaminated foam with multiple users. Disinfectants are NOT effective on porous surfaces
such as foam. Replacement foam components may be purchased separately.
CAUTIONS: DO NOT submerge the foam in any liquid, including water. The foam should not be exposed to light for any
extended period of time. Light will cause discoloration of the foam. Note: Discoloration will not affect the functional features.
There is no need to attempt to "clean" discoloration caused by light exposure.
Soiled foams should be replaced. Remove the cover. Wipe lightly with a damp cloth. DO NOT use soap.
Let dry completely before replacing the cover.
CAUTION: Before cleaning or disinfecting, remove the cover support pad from the hardware.
Cleaning: Hand wash in warm (40°C/104°F) water with soap and a sponge. Rinse with
clean water and wipe dry with a clean cloth. Dry completely before use.
Disinfecting: Wipe gently with a cloth dampened with a household disinfectant.
Rinse with clean, warm water. Wipe dry with a clean cloth. Dry completely before use.
Wipe with a damp cloth.
40C
Machine wash warm.*
Do not tumble dry.
BodiLink Lateral Trunk Support Operation Manual
SURFACE CLEANING COMFORT-TEK FABRIC ONLY
CLEANING AND DISINFECTING ALL FABRICS
SUPPORT FOAM
CLEANING AND DISINFECTING HARDWARE
CARE SYMBOLS
Hand wash.
60C
Machine wash hot.*
Tumble dry low.
Hand wash warm.*
40C
Bleach (1 part bleach: 9
parts water)
1: 9
18
OR
40C
40C
Dry flat.
Line dry.
*maximum temperature shown
40C
1:9
60C