Permobil BodiLink Lateral Trunk Supports Operación Manual página 11

INSTALLATION - TRACK MOUNT ON TRU-COMFORT 2
For GT2 hardware styles. All required tools are provided.
In most cases, the LTS hardware will already be attached to the track mount bracket (E). If needing to adjust the hardware
height and/or width/depth, loosen but do not remove the bolts (A) using the 5mm hex key, and slide the link (D) into
position. Tighten the bolts (A) to secure. This can also be done after the track mount bracket is installed on the TRU-
Comfort 2 shell.
1
Line up the bolts (A) with the safety
washers (B), the slot-lock double washer
(C), the slots on link (D), the slot on the
track mount bracket (E) and the double
nut (F).
Note: The bolts (G) on the LTS hardware
should face up. There are two slots
available on the mounting bracket (E) to
achieve the desired width adjustment.
2
Tighten the bolts (A) using the 5mm hex
key. Follow these steps for each set of
hardware needed. Continue to step 3.
3
Remove the back support cushion (H) from the back shell (J).
4
Line up the provided bolts (K) and the safety washers (L) with the back
shell (J) and the track mount bracket (E).
Note: If applicable, the bracket may be mounted using any of the available
series of holes (M) on the back shell wings. Available shell holes depend on the
size of the back support.
5
Tighten the bolts (K) using the 5mm hex key.
6
Replace the back support cushion (H) on the back shell (J). Continue to the
"Adjustment and Use" section for final hardware adjustments and pad
positioning.
J
L
K
E
BodiLink Lateral Trunk Support Operation Manual
F
H
M
Swing-Away GT2 Hardware; Standard Mounting
E
B
C
D
G
9
Bracket Orientation
A
Alternate Quantum Track Mount
Placement and Orientation Options