Permobil BodiLink Lateral Trunk Supports Operación Manual página 16

INSTALLATION - GT2 SLOT MOUNT ON ACTA-EMBRACE
Attaching GT2 Slot Mount Hardware to Acta-Embrace Back Support Wings.
1
Using the 4mm hex key, release the bolts (A) and the safety washers (B) from
the slot lock bracket (C).
2
With the flat face of the slot mount link (D) on the inside face of the wing (E)
and the bolts (F) facing up, align the slot lock bracket halves with the slot on
the wing (E). The threaded half of the slot lock bracket (C) should be placed on
the back of the wing (E).
Order of installation: bolts (A), safety washers (B), slot lock bracket (C) (the part
with through holes), wing (E), slot mount link (D), slot lock bracket (C) (the part
with threaded holes).
3 Tighten the bolts (A) to secure, and replace the back support cover. Continue
to the "Adjustment and Use" section for final hardware adjustments and pad
positioning.
C
B
A
BodiLink Lateral Trunk Support Operation Manual
Swing-Away GT2 Hardware
E
14
F
C
(with threaded holes)
D
C
D
B
A