ADSC Uninstall / install float
ADSI Uninstall / install seal float
Open the cover of the waste water tank.
1 Funnel
2 Locks
3 Suction turbine air channel
Remove funnel.
Unlock the locks.
Remove the air channel suction turbine.
Note
Check float function.
1 Funnel
2 Float
Remove the float.
Installation information
Pay attention to the correct fitting position during reinstal-
lation.
Open the cover of the waste water tank.
1 Funnel
2 Screw
3 Locks
4 Suction turbine air channel
Remove funnel.
Loosen screws.
Unlock the locks.
Remove the air channel suction turbine.
English 9.808-230.0 Rev. 01 (03/20)
21