AHKB Uninstall / install cable harness
ACBP Uninstall / install control panel board
AKBE Uninstall / install disc brush
AEAA Lay the device on its side for maintenance work
AKBW Uninstall/ install cleaning head
AKMG Uninstall / install brush motor
1 Screws
2 Cover
Unscrew the screws.
Remove cover.
Take the cable harness out of the device.
Installation information
Mind correct installation of the lines.
Note
Bp variant:
1 Main connector
2 Positive terminal with red protective cover
3 Negative terminal with black protective cover
Installation information
Observe the symbols on the main connector.
Assemble the battery cables of the main connector accord-
ingly.
44
English 9.808-230.0 Rev. 01 (03/20)