Connection To The Power Supply - aldes NanoAIR 50 Instrucción De Instalación

EN

7. CONNECTION TO THE POWER SUPPLY

Disconnect the power supply before any operation on the device.
The unit must be connected to the mains by a qualified installer who has read this manual carefully.
The unit's electrical data are inscribed on the device's rating plate.
The device may not be modified, which would void its guarantee.
The Nano Air 50 is intended to be connected to the single-phase 230 V mains.
To facilitate wiring, the Nano Air 50 is supplied with a pre-wired power lead and plug. Connect the Nano Air 50 to the mains via the magnetic trip
automatic circuit breaker incorporated into the fixed wiring system.
The power supply cable is connected to the upper terminal block.
"Ventilation" mode setting
When several Nano Air are connected together (see next page), the position of the jumpers on the electronic
board determine each one's fixed ventilation mode.
26
1~100-230 V 50/60 Hz
Jumpers for setting the
"ventilation" mode
Exhaust Supply