Servicing - aldes NanoAIR 50 Instrucción De Instalación

EN

9. SERVICING

Disconnect the Nano Air 50 power supply before any servicing takes place.
Servicing involves cleaning the Nano Air 50 surfaces regularly to eliminate the dust and cleaning or replacing the filters.
Servicing the heat exchanger and filters (3-4 times a year)
1.
1. Remove the fan unit.
2. Remove the airflow rectifier.
3. Remove the filter located in front of the heat exchanger.
4. Remove the heat exchanger using the cable provided for this purpose.
5. Take care not to drop the heat exchanger.
6. Remove the filter located behind it.
Clean the filters at least every three months.
1. After 90 days in service, the device's LED will blink as a reminder to replace
or clean the filters. It continues to blink every five minutes until the filter has
been serviced.
2. Clean the filters, let them dry and then install them inside the duct.
3. It is permitted to use a vacuum cleaner.
4. The filter service life is three years.
5. Call on Aldes to purchase new filters.
Dirt can build up in the heat exchanger, even when serviced frequently:
1. The heat exchanger needs to be cleaned regularly to guarantee an efficient
heat output.
2. Clean the heat exchanger with a vacuum cleaner at least once a year.
30