Humidity Control - aldes NanoAIR 50 Instrucción De Instalación

To use the Nano Air wireless remote control, the speed button has to be switched from position
On/Off
On/Off
When Night mode is activated, the device switches to the first speed when the lighting in the room is switched off at night. A long sound signals
that the unit has been switched to night mode. A short sound signals that night mode has been switched off.
First speed.
Second speed.
Third speed.
Passive supply
Supply mode. In this mode, the air is brought into the room at the selected speed. When the ventilation units are connected in
series, they run in ventilation mode, regardless of the position of the partition CN7.
Exhaust mode. In this mode, the air is exhausted (by default) or the air is supplied at the selected speed. When connected in
series, the fans run according to the position of jumper CN7.
Heat recovery ventilation
followed by 70 seconds in air intake mode. The heat is thus recovered in this mode.
The humidity is only controlled in
When this mode is activated, the humidity sensor in the Nano Air measures the humidity in the air exhausted from the room and adapts its
ventilation speed according to the difference between the desired humidity level and the actual humidity in the room. If the humidity level in the
room is less than or equivalent to the level set, the device ventilates in second speed. If the humidity level in the room is above the desired level,
the device then switches to third speed. If the humidity level in the room is below the desired level, the device then switches to first speed.
Humidity level selection: 45%.
Humidity level selection: 55%.
Humidity level selection: 65%.
The humidity control function can only be activated/deactivated from the wireless remote control!
Using the Nano Air with its wireless remote control
Nano Air on/off
Speed selection.
Running modes.
mode. In this mode, the room is ventilated naturally with the fan deactivated.
mode. In this mode, the ventilation unit switches every 70 seconds to ventilation and air intake mode,

Humidity control

"Heat Recovery Ventilation »" provided it is activated using one of the buttons on the wireless remote control.
Night mode.
to run position .
EN
29