REMS Akku-Press 22 V ACC Connected Instrucciones De Servicio página 25

eng
Sub-menus/setup and information pages
Makes settings on the drive unit, register the drive unit in the REMS Service Portal, send maintenance messages, set up Wi-Fi connection.
Firmware version
Display: Serial number of drive unit
installed firmware version
Firmware version
Display: Serial number of drive unit
installed firmware version
available firmware version
Installation only possible when the drive unit has been connected with the Internet to the Cloud via Wi-Fi.
Firmware version
Display: Serial number of drive unit
installed firmware version
available firmware version
ERROR REGISTRATION REQUIRED: Drive unit not registered Installation only possible
when the drive unit has been connected with the Internet to the Cloud via Wi-Fi.
Firmware version
Display: Serial number of drive unit
installed firmware version
available firmware version
Data Protection Information: Acknowledge data protection information and start installation.
Firmware version is installed
Do not switch off the drive unit and do not remove the battery or power supply unit during installation.
Select brightness of the LED work lights
Set up via REMS Service Portal/QR code
Display QR code in the OLED display with the right button. Scan the QR code with the mobile terminating device to
open the REMS Service Portal. Register the drive unit. If the drive unit is already registered, the "MANAGE PRODUCT"
page is opened directly.
Set date
If an Internet connection exists, the date is updated automatically on switching on the drive unit. Manual setting is then
not possible.
Set time
If an Internet connection exists, the time is updated automatically on switching on the drive unit. Manual setting is then
not possible.
Select date format
● YYYY-MM-DD
● MM/DD/YYYY
● DD.MM.YYYY
eng
25