Wheel Clamping Instructions - Mondolfo Ferro TBE155 Manual De Uso

WHEEL CLAMPING IN-
STRUCTIONS
WARNING
During the clamping phase, make sure that the
clamps are positioned correctly on the rim to
prevent the wheel from falling.
1) Move the mobile control unit to working
position B.
2) Tilt the tool holder arm to the non-working
position.
3) Use the control lever to move the mobile
platform away from the turntable and raise the
wheel, keeping it in a vertical position.
WARNING
This operation can be extremely dangerous!
Perform it manually if you are absolutely
certain you can maintain the wheel equilib-
rium only.
For heavy, large sized wheels you MUST use a
suitable lifting device.
4) Always using the control level, raise or lower
the turntable holder arm until centring the turn-
table as much as possible with the rim.
5) With the clamps closed, move the wheel
towards the turntable, translating the mobile
platform, then use the switch to open the turn-
table and clamp the rim internally in the most
appropriate position for the rim type, as shown
in figures 13A -13B - 13C - 13D 13E - 13F.
Please remember that clamping on the cen-
tral flange is always considered the safest
approach.
N.B. : for wheels with a rim well, clamp the
wheel so that the well is located on the outer
side (see fig. 13A).
- E - Operator's manual TBE 155
nglIsh
13A
13C
13E
CLAMPING EXTENSIONS
With wheels above 46"
in diameter and without
a flange with central
hole, the wheel may
be clamped using the
set of 4 PA extensions
(optional).
Bayonet-fit the exten-
sion onto the turn-
table clamp mount
and tighten with the
relative wing nut (see
fig. 13G).
13B
13D
UK
13F
13 G
49