Mondolfo Ferro TBE155 Manual De Uso página 55

MOUNTING WITH THE HOOK TOOL
1) Follow the steps described in points 1-6 for
mounting with the bead breaker disc.
2) Move the tool holder arm to the non-working
position; move it to the inner side of the tyre
and rehook it in this position.
3) Make sure that the hook tool is positioned
to the side of the wheel. Otherwise, press the
tool rotation lever and turn it 180°.
4) Move the mobile control unit to working
position D.
5) Move the tool forward so that its red refer-
ence dot is aligned with the external edge of
the rim, 5 mm. away from it (see Fig. 26).
6) Move the mobile control unit to working
position C.
7) Move to the outside of the wheel and visu-
ally check the exact position of the tool and
adjust it as needed. Then turn the turntable
clockwise until the gripper is at the lower
point (6 o'clock).
The first bead is now in the rim.
8) Remove the gripper.
9) Move the mobile control unit to working
position D.
- E - Operator's manual TBE 155
nglIsh
10) Remove the tool from the tyre.
11) Move the tool holder arm to the non-
working position; move it to the outer side of
the tyre and rehook it in this position.
12) Turn the tool 180° using the tool rotation
lever.
13) Attach the gripper at the lowest point (6
o'clock) outside of the second bead.
14) Move the mobile control unit to working
position C.
15) Turn the turntable clockwise approx. 90°
(until the gripper is in the 9 o'clock position).
16) Move the tool forward until its red refer-
ence dot is aligned with the external edge of
the rim, 5 mm away from it.
Start the clockwise rotation making sure that
after a 90° turn, the second bead has started
to slip into the rim well.
Turn it until the gripper is at the lower point
(6 o'clock).
The second bead is now also in the rim.
17) Proceed as described in points 13-18 for
mounting with the disc to correctly remove
the wheel.
26
UK
55