Mondolfo Ferro TBE155 Manual De Uso página 52

A
DEMOUNTING
Tubeless tyres can be demounted in two
ways:
a- If the tyre demounts without difficulty,
once the beads have been broken, press the
bead breaker disc against the inner side of
the tyre until both beads come out of the rim
(see fig. 21).
b- With SUPERSINGLE or very hard tyres the
procedure described above in point a cannot be
used. The hook tool must be used as follows:
1) Move the tool holder arm to the outside
of the tyre.
2) Move the mobile control unit to working
52
position C.
3) Rotate the wheel and at the same time move
the hook tool forward inserting it between the
rim and bead until it is anchored to the bead
(see Fig. 22).
B
20
4) Move the rim about 4-5 cm away from the
tool making sure the bead does not detach
from the tool.
5) Move the hook tool outward so that its red
reference dot is moved near the external rim
edge.
21
6) Move the mobile control unit to working
position B.
7) Insert the lever (A, Fig. 22) between the rim
and the bead to the right of the tool.
8) Keeping the lever pressed down, lower
the wheel to bring the rim edge about 5 mm
from the hook tool.
A
- Operator's manual TBE 155
- E
nglIsh
22