Stihl TS 700 Manual De Instrucciones página 19

Points to be noted with diamond and
composite resin cutting wheels
Object to be cut
– Must be fully supported
– Must be secured so that it cannot
roll or slip away
– Must be protected against vibration
The cutting sequence
The cutting sequence is important when
cutting openings and recesses, etc. The
last cut must always be made in such a
way that the cutting wheel cannot
become bound and so that the user is
not at risk of being injured by the part
that has been cut off or out.
If applicable, leave small ridges of uncut
material to hold the severed part in
position. These ridges can subsequently
be broken through.
A number of points must be decided
before the part is finally severed:
– How heavy is the part?
– In which direction can it move after
being severed?
– Is it under tension?
Helpers must not be put at risk of injury
when the part is broken off or out.
TS 700, TS 800
Cutting in several passes
N Mark cutting line (A).
N Work along the cutting line. If
corrections are necessary, always
reposition the cutting wheel, taking
care to ensure that it is not wedged.
The cutting depth per pass should
not exceed 5 to 6 cm (2" to 2 1/2").
Thicker material must be cut in
several passes.
N Thick-walled workpieces should be
cut with a uniform swinging
movement, back and forth.
Cutting slabs
N Place the slab securely on a non-
slip surface.
N
Cut a guiding groove (A) along the
marked line.
N Cut deeper into the parting cut (B)
with uniform back-and-forth
movements.
N
Leave a ridge (C) of uncut material.
N Cut through the slab at the ends so
the material does not chip.
N
Then break the slab.
English
17