Specifications - Stihl TS 700 Manual De Instrucciones

English

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
44
TS 700
Displacement: 6.0 cu. in.
(98.5 cm
Bore: 2.2 in. (56 mm)
Stroke: 1.57 in. (40 mm)
Engine power to 6.7 hp (5.0 kW)
ISO 7293: at 9300 rpm
Idle speed: 2200 rpm
Max. spindle speed: 5350 rpm
TS 800
Displacement: 6.0 cu. in.
(98.5 cm
Bore: 2.2 in. (56 mm)
Stroke: 1.57 in. (40 mm)
Engine power to 6.7 hp (5.0 kW)
ISO 7293: at 9300 rpm
Idle speed: 2200 rpm
Max. spindle speed: 4600 rpm
Ignition system
Electronic magneto ignition
Spark plug Bosch WSR 6 F,
(suppressed): NGK BPMR 7 A
Electrode gap: 0.02 in. (0.5 mm)
Fuel system
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity:
Air filter
3) Main filter (paper filter) and flocked wire
mesh auxiliary filter
Weight
Weight without cutting wheel, with water
attachment, without fuel
TS 700:
TS 800:
3)
Cutting wheels
The quoted maximum permissible
operating speed of the cutting wheel
must be greater than or equal to the
maximum spindle speed of the cut-off
machine used.
Cutting wheels (TS 700)
Outside diameter:
Hole diameter/spindle
diameter:
Tightening torque:
Composite resin cutting wheels
Minimum outside diameter of
front thrust washer:
40.6 oz
Max. depth of cut:
(1.2 l)
25.6 lbs.
(11.6 kg)
28.7 lbs
(13.0 kg)
14 in.
(350 mm)
0.787 in.
(20 mm)
22 lbf ft
(30 Nm)
4.06 in.
(103 mm)
4.9 in.
(125 mm)
TS 700, TS 800