Replacing The Starter Rope And Rewind Spring - Stihl TS 700 Manual De Instrucciones

Rectify problems which have caused
fouling of spark plug:
– Too much oil in fuel mix.
– Dirty air filter.
– Unfavorable running conditions,
e.g. operating at part load.
Fit a new spark plug after
approx. 100 operating hours or earlier
if the electrodes are badly eroded.
To reduce the risk of fire and burn
injury, use only spark plugs
authorized by STIHL. Always
press spark plug boot (2) snugly
onto spark plug terminal (1) of the
proper size. (Note: If terminal has
detachable SAE adapter nut, it
must be attached.) A loose
connection between spark plug
boot and ignition wire connector in
the boot may create arcing that
could ignite combustible fumes
and cause a fire.
TS 700, TS 800
Replacing the Starter Rope
and Rewind Spring
Replacing the starter rope
2
3
2
2
N Remove the hose (1) from the guide
of the starter cover
N Remove screws (2)
N Remove the starter cover (3) from
the engine
1
N Remove the spring clip (4)
N Remove the rope rotor with
washer (5) and pawls (6)
1
N
Lever the rope out of the starter
handle with a screwdriver
N Remove the remainder of the rope
from the rotor and starter handle
N Thread a new ElastoStart starter
rope from top to bottom through the
starter handle and rope guide
bush (7)
N Thread the rope through the rotor
and secure it in the rotor with a
simple overhand knot
English
7
35