Stihl TS 700 Manual De Instrucciones página 32

English
N Set the choke (4) according to the
engine temperature
c If engine is cold
e if the engine is warm (even if the
engine is already running but is still
cold or if the warm engine was shut
off for less than 5 min)
o if the engine is hot (if the hot
engine was switched off for longer
than 5 min)
N Press the button (5) of the
decompression valve before each
starting procedure
N Press the bulb (6) of the fuel pump
7-10 times – even when the bulb is
still filled with fuel
30
Starting
N Place the cut-off machine carefully
on the ground, ensuring that the
cutting wheel cannot touch the
ground or any objects. There must
not be anyone within the swivel
range of the cut-off machine
N Make sure you have a firm footing
N Press the cut-off machine firmly
against the ground, holding the
handle with your left hand, thumb
wrapped round the handle
N Place your right foot through the
rear handle
N Pull the starter grip slowly with your
right hand until you feel it engage –
then give it a brisk strong pull – do
not pull out the starter rope all the
way
Do not let the starter grip snap
back – it may break! Guide it
back into the housing in the
opposite direction so that it can
rewind properly.
When the engine has turned over for
the first time
N Set choke lever (4) to o – press the
button of the decompression valve
again before each starting attempt
and continue cranking
Once the engine is running
N Squeeze throttle trigger fully and let
engine run at full throttle for
approx. 30 s
N When it has warmed up, set the
choke lever to e
N The Master Control lever (3) moves
to the normal positionF when the
throttle trigger is squeezed
If the carburetor has been set correctly,
the cutting wheel should not rotate when
the engine is idling.
TS 700, TS 800