Stihl TS 700 Manual De Instrucciones página 26

English
4
3
5
N Move the adjusting lever (5) to
position A
N Screw in the bolt (4) and tighten up
N Insert the square nut into the guide
in the guard and hold it in place
N
Screw the shorter banjo bolt (3) and
washer on to the adjusting lever and
tighten up
N Turn the guard in the direction of the
arrow until the adjusting lever points
forwards
24
A
7
N to relax the poly V-belt, loosen the
hexagon head screws (6)
N Turn the tensioning nut (7)
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
N Remove the hexagon bolts.
N Pull the V-belt guard (8) off to the
front and remove the poly V-belt
from the front pulley
N Remove the "bearing and guard" (9)
6
6
6
N
N
N
N
8
9
N
N
N
N
9
Fit the "bear with guard" (9) on the
outboard side of the cast arm - at
the same time, guide the poly v-belt
over the belt pulley
Slide on the V-belt guard
Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard.
Screw in the hexagon bolts, but do
not tighten them yet
1
2
1
Insert the longer banjo bolt (1)
through the connector (2) of the
water attachment
Note the connector position
Insert the square nut into the guide
in the guard and hold it in place
Fit the water attachment to the
adjusting lever with the longer banjo
bolt – screw in the banjo bolt
TS 700, TS 800