Stihl TS 700 Manual De Instrucciones página 27

Continue as described in the chapter
"Tensioning the V-belt".
Version B (TS 700, TS 800)
N Disassemble the abrasive wheel
(see "Fitting / replacing an abrasive
wheel")
1
A
N Move the guard to the position
illustrated
N pull out the plugs (arrows)
N Mount the adjusting lever (1) in
position A
N Press the plugs into the free holes
N Undo the nuts (2)
N
Remove the washer (3)
TS 700, TS 800
N Turn the guard in the direction of the
arrow until the adjusting lever points
downwards
4
4
5
4
N to relax the poly V-belt, loosen the
hexagon head screws (4)
N Turn the tensioning nut (5)
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
N Remove the hexagon bolts
6
7
N Pull the V-belt guard (6) off to the
front and remove the poly V-belt
from the front pulley
N Remove the "bearing and guard" (7)
7
N Fit the "bear with guard" (7) on the
outboard side of the cast arm - at
the same time, guide the poly v-belt
over the belt pulley
N Slide on the V-belt guard
N Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard
N
Screw in the hexagon bolts, but do
not tighten them yet
N Refit the water attachment parts to
the guard
Continue as described in the chapter
"Tensioning the V-belt".
English
25