Tensioning The Ribbed V-Belt; Fitting / Replacing An Abrasive Wheel - Stihl TS 700 Manual De Instrucciones

English
Tensioning the ribbed
V-belt
This machine is equipped with an
automatic spring-action V-belt
tensioning device.
1
1
2
1
Prior to tensioning of the ribbed v-belt,
the hexagon head screws (1) must be
loosened and the arrow on the
tensioning nut (2) must point to 0.
N otherwise loosen the hexagon head
screws (1) and the tensioning
nut (2) with the combination wrench
counterclockwise –
approx. 1/4 turn, as far as
possible = 0
1
1
1
N to tighten the ribbed v-belt, fit the
combination wrench over the
tensioning nut as illustrated
The tensioning nut is spring-
loaded – hold the combination
wrench securely.
26
N Turn the tensioning nut clockwise
approx. 1/8 turn – the tensioning nut
will be engaged by the spring
N Continue turning approx. 1/8 turn –
up to the stop
Do not turn the combination
wrench further by force.
The ribbed V-belt is automatically
tensioned by the force of the spring in
this position.
N Remove the combination wrench
from the tensioning nut
N Tighten hexagon head screws (1)
on the V-belt guard
Retensioning the poly ribbed V-belt
The poly V-belt is retensioned without
the aid of the tensioning nut.
N
Unscrew the three hexagon bolts on
the V-belt guard
The poly V-belt is automatically
tensioned by the force of the spring.
N Retighten the hexagon bolts.
Fitting / replacing an
abrasive wheel
The engine must be switched off for
fitting or replacement – set Master
Control lever to STOP or 0.
Blocking the shaft
N Slide the locking pin (1) through the
bore in the V-belt guard
N
Turn the shaft with the combination
wrench until the locking pin (1)
engages in a bore behind the guard
TS 700, TS 800