LUND 68280 Manual Original página 12

EN
food is dried, air fl ows through the food products and any impurities may remain on the dried
products.
Do not place any electrical equipment above the appliance. During operation, the appliance
releases hot and humid air, which can cause a short circuit in the electrical system and lead
to an electric shock.
It is forbidden to drill any holes in the product, as well as make any other modifi cations to the
appliance not described in the manual.
Move the appliance only when cooled, grasping the housing. Do not move the appliance by
pulling on the power cord.
The temperature at the place of installation and use of the appliance must be within the range
of +10 C ÷ +38 C, and the relative humidity must be below 90% without condensation.
O O
Recommendations for connecting the appliance to the power supply
Before connecting the appliance to the power supply, make sure that the voltage, frequency
and performance of the mains correspond to the values shown on the appliance's rating
plate. The plug must fi t into the socket. It is forbidden to modify the plug in any way.
The appliance must be connected directly to a single socket of the mains. It is forbidden to
use extension cords, adapters or double sockets. The mains supply circuit must be fi tted with
a protective conductor and a 16 A protective device.
Avoid contact of the power cord with sharp edges, hot objects or surfaces. During operation,
the power cord must always be fully extended and the position of the power cord must be
set so that it does not become an obstacle during operation. The power cord should not be
placed in a manner which would pose a risk of tripping. The power socket should be located
in a place where it is always possible to quickly remove the appliance's power cord plug.
Always pull the power cord by the plug housing when unplugging it, never by the cord.
If the power cord or the plug is damaged, immediately disconnect it from the mains and
contact an authorised service centre of the manufacturer for replacement. Do not use the ap-
pliance with a damaged power cord or plug. The power cord or plug cannot be repaired and
must be replaced with a new one that is free of defects if these components are damaged.
Replacement of the power cord and plug must be carried out by an authorised service centre
of the manufacturer.
Recommendations for the appliance use
WARNING! The appliance's housing can be hot during operation and shortly after use. Do
not touch it, as it may cause burns. Wait for the appliance's housing to cool down.
Food products should be cut into small pieces before placing them on trays. The smaller the
food pieces, the faster they will be dried and the lower the drying temperature will be required.
Always lay the food product starting from the lowest tray. Do not place the products too close
so as to allow for air circulation. Place the food products on one tray in one layer. The prod-
ucts laid on the tray should not touch the tray or housing above.
Make sure that the fl oor near the appliance is not slippery. This will prevent slipping, which
can cause serious injuries.
Keep the appliance under constant supervision during its operation. Before checking the
O R I G I N A L I N S T R U C T I O N S
12