Publicidad
2
5
22
English
TO REMOVE/REPLACE COMFORT LINING
The comfort lining is secured to the helmet by 4 plastic bosses (1).
1
To remove the lining, undo 4 bosses by grasping the lining as close to each
3
boss as possible (2) and pulling straight up (3).
Note the front & back, top & bottom sides of the lining for replacement.
4
NOTE:
removable to offer a bit more room if desired. Gently remove it from the pad.
Once removed this foam layer will not reattache securely (4).
To wash the comfort lining, put it into lukewarm water with small amount of laundry
soap or your own shampoo and wash gently by hand. Rinse well with fresh water
and wipe off with a soft cloth. Dry it in the shade at ambient temperature.
WARNING: Never use petrol, thinner, benzene or any other solvents.
To replace the lining, place the bosses over their plastic receptacles and push
6
them home (5)&(6).
WARNING:
properly positioned along the inside shape of the EPS (a.k.a. Styrofoam)
liner. If the comfort lining is not properly installed, the frame of the comfort
lining may fold when you put on and take off the helmet, which may injure
your skin, etc. Whenever you feel something is wrong with the comfort
lining, check that the lining is properly installed.
The lining is equipped with a 5mm surface foam layer. The layer is
When reinstalling the comfort lining, be sure the lining is
Publicidad
